Run Commands

Docker Desktop

Learn how to install locally with Docker Desktop.

Before You Start #

Operating System:

1. Install Docker Desktop #

  1. Install Docker Desktop for your machine.
  2. Navigate to Settings for Mac, Windows, or Linux.
  3. Select Apply & Restart.

2. Install Pachctl CLI #

Operating System:

3. Install & Configure Helm #

  1. Install Helm:
brew install helm
  1. Add the Pachyderm repo to Helm:
helm repo add pachyderm https://helm.pachyderm.com  
helm repo update  
  1. Install PachD:
💡

Open your browser and check http://localhost before installing. If any other tools are using the same port as Pachyderm, add the following argument to the below command: --set proxy.service.httpPort=8080

Version:

This may take several minutes to complete.

4. Verify Installation #

  1. In a new terminal, run the following command to check the status of your pods:
kubectl get pods
NAME                                           READY   STATUS      RESTARTS   AGE
pod/console-5b67678df6-s4d8c                   1/1     Running     0          2m8s
pod/etcd-0                                     1/1     Running     0          2m8s
pod/pachd-c5848b5c7-zwb8p                      1/1     Running     0          2m8s
pod/pg-bouncer-7b855cb797-jqqpx                1/1     Running     0          2m8s
pod/postgres-0                                 1/1     Running     0          2m8s
  1. Re-run this command after a few minutes if pachd is not ready.

5. Connect to Cluster #

pachctl connect http://localhost:80 
⚠️

If you set the httpPort to a new value, such as 8080, use that value in the command. pachctl connect http://localhost:8080

Optionally open your browser and navigate to the Console UI.

💡

You can check your Pachyderm version and connection to pachd at any time with the following command:

pachctl version
COMPONENT           VERSION  

pachctl             2.6.10  
pachd               2.6.10